Specifications

Bulletin No. VVDED397044US R12/00 Section 1—Installation & Configuration
December 2000 Hardware Setup
© 1998–2000 Schneider Electric All Rights Reserved
19
Figure 12: Terminal Locations (Product Frame Size 7)
Cable Routing Practices
When wiring the ATV58 drive controllers to a MODBUS PLUS network,
follow all wiring practices required by national and local electrical codes.
Observe the following guidelines:
• Avoid areas of high temperature, moisture, vibration, or other
mechanical stress.
• Secure the cable where necessary to prevent its weight and the weight
of other cables from pulling or twisting the cable.
• Use cable ducts, raceways, or other structures to protect the cable.
Use these structures for signal wiring paths. They should not contain
power wiring.
Control Terminals
Power Terminals
Ground Terminal