Installation guide

214 Installing Custom Cable Systems
890 USE 100 00
D .1 Overview
This chapter describes how to install the network cable system without
the use of Modicon taps and drop cables. This method uses inline and
terminating connectors that are available from Modicon. It is intended
primarily for the installer, but can also be useful to the planner in
estimating time and labor requirements.
You will be performing the following actions to install and check the
cable:
V Route the cable in accordance with the layout diagram described in
Chapter 4.
V At each cable drop location except the two extreme ends, connect
the cable signal conductors and shield to an inline connector.
V At the cable drop locations at the two extreme ends, connect the
cable signal conductors and shield to a terminating connector.
V If the network node devices are installed, check that each one is
grounded to a proper site ground.
V Label the cable segments to assist in future maintenance.
V Inspect the cable run and check the cable’s continuity before
connecting it to the network node devices.