Installation guide

158 Connecting an RR85 Repeater
890 USE 100 00
If the cable segments are not labeled, or if you do not have a network
layout diagram, you can still connect the cables to the Repeater and
test your installation. The two rear panel ports of the Repeater operate
identically. When you have connected the cables, document your
connection to facilitate future maintenance.
Refer to Figure 61. Connect the two cable connectors to the Repeater’s
rear panel connectors. If the network links are active, the unit’s
MODBUS PLUS PORT 1 and MODBUS PLUS PORT 2 indicators
should begin flashing.