User manual

Magelis C - 21
3. Using XBT L100• software
C
The equipment creation/modification window differs according to the
protocol selected
.
Importing PLC symbols
It is possible to associate variables files with equipment, which appears
in the list. These files must have been generated from either PL7,
Concept or Twidosoft PLC programming software.
The "Advanced >>" button calls up a zone at the bottom of the
configuration window where this association can be made.
XBT ref. Note
N200/N400
R400
Mono-equipment
TWIDO
(4)
ULTIMA
(18)
QUANTUM
(23)
Modbus master
Modbus
MASTER
(1)