User manual

Magelis B - 5
B
B
1. Introduction: Display unit operating concepts
 HMI
For XBT N display units, depending on the mode chosen, the keypad will
either be in control mode or in input mode (see chapter A,
section Presentation of the commands, Page 8). The button labels are
therefore interchangeable.
XBT ref. Note
N200/N400/N410
NU400
R400/R410
No indicator lights
No printer link
Program
the display unit
with XBT L100•
1
2
3
4
7
8
9
0
+/-
•
5
6
- Display data
from the control system
- Indicate faults in
the control system
Communicate with
the PLC
(Telemecanique,
Modicon, etc)
- Modify the PLC parameters
- Acknowledge an alarm
- Send commands to the
control system
- Enter a value
Communication
status
indicator light
Communicate
with the printer
- Send commands to
the control system
- Change the page