User manual

Magelis A - 19
A
2. The XBT L100• program
 Presentation
XBT L100• is the configuration software for the Magelis range of
operator terminals.
This software runs on computers using Windows 98SE, 2000 and XP
operating systems.
 Installation
In order to use XBT L100• software, the following minimum configuration
is required:
- PC Pentium II 350 MHz
- 4x CD-ROM minimum
- Microsoft 98SE, 2000 or XP
-128 MB RAM
- 30 MB of space available on the hard disk
- SVGA video card or better
- Mouse or compatible pointing device
To install the XBT L100• software, insert the CD-ROM in the CD-ROM
drive and follow the on-screen instructions.
If the installation program does not run automatically, select Run from
the Start menu. Then, type “D:\SETUP.EXE” (where D: is your CD-ROM
drive) and press Enter. During installation, you will be asked which
protocols and components you wish to install.
Installation of the Xway driver is launched automatically after installation
of XBT L100•. This driver is used to transfer applications between the PC
and the display unit.
Once installed, this driver can be configured from the Windows control
panel.
The USB drivers are not installed automatically, but are included on the
XBT-L100• installation CD-ROM. These drivers are requested
automatically by Windows when the USB cable is connected to the PC.
They can also be installed by connecting the USB cable.