User manual

E - 6 Magelis
1. Troubleshooting/Problems and solutions
Fault Cause Remedy
Import impossible
XBT--> PC
Application protected by password Ask the creator of the application for
the password
Inoperative keys Locking by the dialog table Check the PLC program
Incorrect terminal configuration Check that the terminal
configuration is correct for "input" or
"control" mode
"No application" message No application Transfer an application
No printing No connection Connect the cable and check that it
is connected correctly at both ends.
Then check that the printer is
switched on.
The cable connecting the printer to
the terminal is incorrect
Check that the cable is the
appropriate type
Incorrect printer configuration Refer to the printer manual to check
that the configuration saved by the
terminal is the same as the current
configuration
Abnormal printing Every other line is printed The terminal is configured as LF
rather than auto-LF
Lines are printing one on top of the
other.
The terminal is configured as auto-
LF rather than LF