User manual

Magelis C - 77
7. Description of dialog-table words
C
- Bit 2: END_OF_ENTRY_ON_ENTER: Set to 1 once the operator has
confirmed completion of the field by pressing ENTER.
- Bit 3: END_OF_ENTRY_ON_ESC: Set to 1 once the operator has
cancelled completion of the field by pressing ESC.
- Bit 4: END_OF_ENTRY_ON_TIMEOUT: Set to 1 if the operator
neither confirms nor cancels completion of the field within one minute.
 Print command
This 16-bit word is split into two bytes: The most-significant byte defines
which print function to use and the least-significant byte is used to switch
from the parameters to the selected print function.
The list of function codes and parameters supported is as follows:
Once the terminal has taken account of the request (this does not mean
that printing has finished), it writes 0xFFFF to this word.
You will notice that there are several bits dedicated to printing in the
status word: These bits are PRINTING_IN_PROGRESS,
PRINTING_FAULT AND PRINTING_STOPPED.
XBT -> PLC
Report
Bit 15 4 3 2 0
XBT<->PLC Print function code Function data
MSB LSB Function
0x02 Any Print the alarm log
XBT -> PLC
Report
Bit 15 7 6 5 0
XBT ref. Note
N200/N400/N410
NU400
R400/R410
No printer link