User manual

Magelis C - 63

6. Transferring an application

 Connecting the display unit

For transfers, the link between the display unit and the PC uses either

an RS232C serial cable or a USB cable.

For more information about connections, see chapter A,

section Connection, Page 11.

 Starting up the display unit

Refer to the quick reference guide supplied with the product.

 Importing an application

An application is imported by selecting Import from the Transfer menu.

Data is imported into a new application, not into the current application.

Importing begins with checking the import protection (see section Step 2

- Configure the terminal parameters, Page 15).

Next, the XBT L100•/Connected display unit communication protocols

are checked.

The import operation takes place after the checking phase.

XBT ref. Note

WARNING

ELECTRICAL CONNECTIONS

- Disconnect the power supply before connecting the serial link.

- Only connect one type of serial link at a time.

- Tighten both connector fixing screws.

Failure to follow this instruction can result in death, serious

injury, or equipment damage.