User manual

C - 60 Magelis
5. Simulation
There is one line for each variable used in the page being displayed. If
the same variable is used several times in the page, it only appears once
in the grid.
It is possible to change the value of a variable by entering a new value
in the box corresponding to the average of the PC keypad. Write-only
fields do not appear until the display unit has entered an input.
 "Alarms" tab
The grid representing the table of word bits used is similar to that used
to create alarms. In addition, the only active boxes are those
corresponding to the bits on which alarms have been defined. These
boxes display the value of the corresponding bit (- or x), and double-
clicking on one of these boxes simulates the change of state of the alarm
bit.
XBT ref. Note
N200 No alarm management