User manual

Operating Principles of XBT Terminals
33003962 11/2011 95
Transfer Mode
Overview
In transfer mode the XBT terminal communicates with the Vijeo-Designer Lite
configuration software. Software applications can be transferred in both directions.
The XBT terminal automatically enables the transfer mode when it is connected to
a PC via a communication cable. No operator action on the terminal is necessary in
this mode.
Procedure of Transferring Software Applications
For transferring software applications to or from your XBT terminal perform the
following steps:
Step Action
1 Connect your XBT terminal to a PC running the Vijeo-Designer Lite software. For
the suitable Schneider cable see Connecting XBT Terminals to a PC, page 60.
Result: The XBT terminal automatically detects the connection to a PC, enables
the transfer mode and waits for software application transfer.
2 From the Vijeo-Designer Lite software at your PC start the software application
transfer.
For transferring software configuration data from the PC to the XBT terminal,
select the menus Device → Download....
For transferring software configuration data from the XBT terminal to the PC,
select the menus Device → Upload....
XBT terminals that are equipped with a communication LED indicate data
interchange with a PC by a blinking communication LED.