User manual

Connecting XBT Terminals
33003962 11/2011 71
Connecting XBT Terminals Powered by the PLC to a PLC
Overview
The following XBT terminals need 5 V power that is usually supplied by the PLC but
may also be supplied by an external 5 VDC power supply:
z XBT N200
z XBT N400
z XBT R400
z XBT RT500
Connection to Twido / Micro / Premium / Nano, Power by PLC
Use the Schneider cable XBT Z9780 (RS485) to connect XBT N200 / N400 / R400
or RT500 terminals to the following Schneider PLCs that provide the required
5 VDC:
z Twido
z Micro
z Premium
z Nano
Connection to Twido / Micro / Premium / Nano via Schneider cable XBT Z9780
(RS485)
Connection to Modicon M340, Power by PLC
Use the Schneider cable XBT Z9980 (RS485) to connect XBT N200 / N400 / R400
or RT500 terminals to a Modicon M340 PLC that provides the required 5 VDC.
CAUTION
VOLTAGE DAMAGE TO EQUIPMENT
Connect the serial link connector with power off and tighten connector screws.
Failure to follow these instructions can result in injury or equipment damage.