User manual

Connecting XBT Terminals
33003962 11/2011 65
Connecting XBT Terminals Powered by an External Power Supply to a PC
Overview
The following XBT terminals need an external power supply supplying 24 VDC:
z XBT N410
z XBT N401
z XBT NU400
z XBT R410
z XBT R411
z XBT RT511
When connecting these terminals to a PC for exchanging software configuration
data with Vijeo-Designer Lite it is also required to connect an external power supply
via the 24 VDC power supply connector that is included in the scope of delivery of
these XBT terminals.
NOTE: For connecting these XBT terminals to a PC use the Schneider cables
described in the following sections.
Connecting XBT N410 / N401 / NU400 / R410 / R411 to a PC
XBT N410 / N401 / NU400 / R410 / R411 terminals can be connected to a PC in 2
different ways:
z via the serial port of the PC using the Schneider cable XBT Z915
z via the USB port of the PC using the Schneider cables XBT Z925 and TSX-
CUSB485
CAUTION
VOLTAGE DAMAGE TO EQUIPMENT
Connect the serial link connector with power off and tighten connector screws.
Failure to follow these instructions can result in injury or equipment damage.