User manual

Connecting XBT Terminals
62
33003962 11/2011
Connecting XBT Terminals Powered by the PLC to a PC
Overview
The following XBT terminals need 5 V power that is usually supplied by the PLC:
z XBT N200
z XBT N400
z XBT R400
z XBT RT500
When connecting these terminals to a PC for exchanging software configuration
data with Vijeo-Designer Lite, the 5 V required by the terminal must be provided by
the PC.
NOTE: For connecting XBT terminals to a PC use the Schneider cables described
in the following sections.
CAUTION
VOLTAGE DAMAGE TO EQUIPMENT
Connect the serial link connector with power off and tighten connector screws.
Failure to follow these instructions can result in injury or equipment damage.