User manual

Inserting Labels
33003962 11/2011 51
Graphical Representation of Correctly Inserting Labels into XBT R / XBT RT Terminals
The graphic below shows how to correctly insert an insert label into an XBT R /
XBT RT terminal:
Inserting Labels into XBT R / XBT RT Terminals
For inserting insert labels into XBT R / XBT RT terminals proceed as follows:
Step Action
1 Press the pre-cut insert label of your choice out of the insert label sheet.
2 Take your XBT R / XBT RT terminal and turn it around so that you can see its
rear panel. On the right-hand side of the rear panel, located directly behind the
overlapping display, you will find the opening for the insert label.
3 Insert the insert label cautiously into this opening (as shown in steps 1 and 2 of
the above figure) until the key symbols / texts on the wide part of the insert labels
have disappeared and the wide part of the insert label is flush with the opening.
There will be merely the small flap of the insert label with the double arrow being
visible outside the terminal.