User manual

Inserting Labels
50
33003962 11/2011
Graphical Representation of Correctly Inserting Labels into XBT N Terminals
The graphic below shows how to correctly insert an insert label into an XBT N
terminal:
Inserting Labels into XBT N Terminals
For inserting insert labels into XBT N terminals proceed as follows:
Step Action
1 Press the pre-cut insert label of your choice out of the insert label sheet.
2 Take your XBT N terminal and turn it around so that you can see its rear panel.
On the left-hand side of the rear panel, located directly behind the overlapping
display, you will find the opening for the insert label.
3 Insert the insert label cautiously into this opening (as shown in steps 1 and 2 of
the above figure) until the 4 key symbols / texts have disappeared and the only
sign that can still be seen of the insert label is the double arrow.
4 Turn your XBT N terminal around and check at its front side that all 4 symbols /
texts are clearly visible at the keys. If the texts / symbols are not clearly visible,
insert the insert label a bit further into the opening. A graphical example of a not
correctly inserted insert label is provided for XBT R / RT terminals below in this
chapter.
5 If the texts / symbols are clearly visible on the front of the terminal, take the part
(with the double arrow sign) of the insert label that is still visible on the rear of the
terminal and slide this flap into the slit indicated in step 3 of the above figure. The
flap should now be flush with the rear of the terminal (see step 4 of the above
figure).
If the insert label has not correctly been inserted into the XBT terminal, the flap
of the insert label will be too long to fit into this slit. A graphical example of a not
correctly inserted insert label is provided for XBT R / RT terminals below in this
chapter.