User manual

Insert Labels
42
33003962 11/2011
Insert Labels XBT N
Overview
XBT N terminals are delivered with an insert label sheet providing the following label
types to assign different texts or symbols to the keys:
z service key labels
z function key labels
z blank labels
All labels are pre-cut and just have to be pressed out of the label sheet.
The ready-to-use service key and function key labels can directly be inserted into
the XBT N terminal as described in section Inserting Insert Labels, page 49.
To print your own text or symbols on the blank labels, use the Vijeo-Designer Lite
configuration software.
New label sheets can be ordered at Schneider with the following part numbers:
Service Key Labels for XBT N Terminals
If you have configured your XBT N terminal for input variant in the Vijeo-Designer
Lite configuration software, insert the following service key label into your XBT N
terminal.
Service key label XBT N
Service key label XBT N401 (with LEDs)
XBT Terminal Label Sheet Part Number
XBT N200 / XBT N400 / XBT NU400 / XBT N410 XBLYN00
XBT N401 XBLYN01
WARNING
UNINTENDED EQUIPMENT OPERATION
Make sure that the text/symbols on your insert label always correspond to what is
configured for your XBT terminal in the Vijeo-Designer Lite configuration software.
Otherwise the keys of your terminal will not initiate the actions indicated on them.
Failure to follow these instructions can result in death, serious injury, or
equipment damage.