User manual

Chapter 4 Installation and Wiring
4-15
4.4 USB Cable Clamp Attachment/Removal
This clamp is used to prevent the USB cable connected to the USB Host Interface on the bottom of the OT
unit from being unplugged due to vibration or other causes.
4.4.1 XBT OT2110/2210 Series
 Attachment
(1) Insert the USB holder into the slot in front of the OT unit’s USB port and pull it down and forward.
(2) Pass the band of the USB cable clamp through the bridge of the USB holder.
(3) Insert the USB cable into the port. Fasten the band around the plug and secure it with the clamp.
DANGER
ELECTRIC SHOCK
Unplug the unit’s Power Cord from the 24 VDC power supply prior to attaching or detaching any
connector(s) to or from the unit.
Failure to follow these instructions can result in death, serious injury, or equipment damage.
1
2
Bridge
USB Holder
Clamp
USB Cable
USB Holder