User manual

Magelis XBT OT User Manual

4-10

XBT OT5220/5320 Series

(1) Confirm that the power cord is unplugged from the power supply.

(2) Remove the power connector (plug) from the main unit.

(3) Loosen the three screws in the center of the Power Connector (plug).

(4) Strip the sheath of the power cord, twist the wire ends, insert them into the bar terminals.

(5) Fix them with screws.

(6) Attach the Power Connector (Plug) to the OT and fix it to the OT main unit with right/left tightening

screws.

• Use a flat-blade screwdriver (size 0.6 x 3.5) to tighten the terminal screws.

The torque required to tighten these screws is 0.5 to 0.6N.m[4.4-5.3 lb-in].

• Do not solder the cable connection.

• Be sure to twist the power cords together, up to the power connector.