Safety Instructions

5.2 "First Setup"
A "First Setup" is required when the controller supply is switched on
for the first time or after the factory settings have been restored.
Switching on the device
■
The power stage supply is switched off.
▶
Disconnect the product from the the fieldbus during commissioning
in order to avoid conflicts by simultaneous access.
▶
Switch on the controller supply.
◁
The device goes through an initialization routine, all LEDs are tes-
ted, all segments of the 7-segment display and the status LEDs
light up.
After the initialization, the fieldbus interface must be configured. The
product is configured via the integrated HMI or the commissioning
software.
First Setup via HMI
Fault Edit Value Unit
Op
Mon
Conf
Fault Edit Value Unit
Op
Mon
Conf
<1s
ESC
Fault Edit Value Unit
Op
Mon
Conf
Fault Edit Value Unit
Op
Mon
Conf
IP
Subnet
<1s
2 x
<1s
ESC
1.
2.
<1s
2 x
<1s
ESC
1.
2.
<1s
2 x
<1s
ESC
1.
2.
<1s
2 x
<1s
ESC
1.
2.
Fault Edit Value Unit
Op
Mon
Conf
Fault Edit Value Unit
Op
Mon
Conf
Fault Edit Value Unit
Op
Mon
Conf
Fault Edit Value Unit
Op
Mon
Conf
Fault Edit Value Unit
Op
Mon
Conf
<1s
2 x
<1s
ESC
1.
2.
Fault Edit Value Unit
Op
Mon
Conf
Fault Edit Value Unit
Op
Mon
Conf
<1s
2 x
<1s
ESC
1.
2.
<1s
2 x
<1s
ESC
1.
2.
<1s
2 x
<1s
ESC
1.
2.
<1s
2 x
<1s
ESC
1.
2.
Fault Edit Value Unit
Op
Mon
Conf
<1s
2 x
<1s
ESC
1.
2.
Fault Edit Value Unit
Op
Mon
Conf
<1s
2 x
<1s
ESC
1.
2.
Fault Edit Value Unit
Op
Mon
Conf
<1s
2 x
<1s
ESC
1.
2.
Fault Edit Value Unit
Op
Mon
Conf
<1s
2 x
<1s
ESC
1.
2.
=
=
=
Figure 6: First Setup via the integrated HMI
5 Commissioning
LXM32M
38 Modbus-TCP module
0198441113843, V1.01, 01.2012