User`s manual

Use of I/O Units, INTERBUS Adapters and Branch Interface Modules
26
Mechanical Construction of the I/O Unit and Adapter
General
information
about
construction
The I/O modules have the standard Momentum housing.
A sliding label is delivered together with the I/O unit. It fits onto the space on the front
of the adapter. The signal names belonging to the sensors and actuators can be
entered here.
The name of the bus adapter can be seen through the space on the right-hand side
of the sliding label.
Above and below the label tag there are ventilation slots to allow natural airflow for
cooling when mounted vertically.
In the slots underneath the labeling film there are LEDs for diagnostics, status and
operating elements (170 INT 120 00).
Diagram of the
I/O Module with
Adapter
View of an I/O module with mounted adapter, used here for connecting copper
wires.
1 Bus adapter 170 INT 110 03
2 I/O module
1
2