User`s guide

Bulletin No. VVDED397053US Section 1—Hardware Set-Up
November 2000 Bus Voltage Measurement Procedure
© 2000 Schneider Electric All Rights Reserved
5
Figure 1: DC Bus Voltage Measurement Point Locations
(ATV58HU09M2 shown)
+
–
L1 L2 L3 PA PB U V W
L1 L2 + – UVW
L1 L2 L3 PA PB U V W
–
+
+
–
+
–
ATV58•D16M2–D46M2
ATV58•D28N4–D79N4
ATV58•U09M2–U18M2
ATV58•U29M2–D12M2
ATV58•U18N4–D23N4
J18-7
J18
Power
Terminal
Block
}
}
}
The J18 connector is in the upper left hand corner of the main control
board behind the flexible shield. Use a thin probe to access the
connector pin.
Flexible
Shield
Main Control
Board
VVDED397053USBook Page 5 Tuesday, November 28, 2000 9:01 AM