User`s guide

Bulletin No. VVDED397053US Section 2 — Software Set-Up

November 2000 Parameter Configuration

SECTION 2—SOFTWARE SETUP

PARAMETER CONFIGURATION

Apply 24 Vdc to the Interbus-S communication card before powering up

the ATV58 drive controller. When first powered-up, the ALTIVAR 58 drive

controller automatically recognizes the Interbus-S communication card.

The card provides access to the configuration 8—COMMUNICATION

menu from the keypad display (VW3A58101), handheld programming

terminal (VW3A58102U), or PC software (VW3A8104). (Cable

VW3A8106 is required to connect the PC to an ATV58 drive controller.)

To configure the Interbus-S communication card, select the

8—COMMUNICATION menu and access the configuration parameter,

AdrC.

Parameter AdrC may be set to 0 or 1.

• When set to 0, the drive controller is independent from the bus. In this

state, the Interbus-S card exchanges process data and messages with

the bus, but does not send them to the drive controller. This status can

be verified by a STATUS service. The “logical status” parameter in the

reply is equal to 2 (L_STAT_NBR_SVC_LIMIT).

• When the parameter is set to 1, the Interbus-S card sends process

data and messages from the bus to the drive controller.

This state

represents normal operation and can also be verified by a STATUS

service

. The “logical status” parameter in the reply is equal to 0

(L_STAT_COMM_READY).

Set the value of the AdrC parameter to 1 to enable transmission of data

from the bus to the drive controller.

This allows the card to perform

modifications within the drive controller without interference from the bus

or interruption of communication.

NOTE: If parameter PrO equals “INTERBUS-S,” this indicates that the

card has been recognized.

See Figure 7 for reference and observe the following guidelines:

• Using the Phoenix Contact IBS CMD G4 software, the Interbus-S

module in the logic controller must be configured to recognize the

Interbus-S communication card in the ALTIVAR 58 drive controller.

• The communication bus cables (in and out) must be connected to the

communication card in the ALTIVAR 58 drive controller.

VVDED397053USBook Page 13 Tuesday, November 28, 2000 9:01 AM