Specifications

How to Configure the Island
31004624 8/2009 53
What is the RST Button?
Summary
The RST function is basically a Flash memory overwriting operation. This means
that RST is functional only after the island has been successfully configured at least
once. All RST functionality is performed with the RST button, which is enabled only
in edit mode (see page 50).
Physical Description
The RST button is located immediately above the CFG port (see page 32), and
behind the same hinged cover:
Holding down the RST button for 2 seconds or longer causes Flash memory to be
overwritten, resulting in a new configuration for the island.
If the island is already auto-configured, there is no consequence other than the
island stops during the configuration process. However, island parameters that you
previously customized with the Advantys Configuration Software are overwritten by
default parameters during the configuration process.
Engaging the RST Button
To engage the RST button, it is recommended that you use a small screwdriver with
a flat blade no wider than 2.5 mm (.10 in). Do not use a sharp object that might
damage the RST button, nor a soft item like a pencil that might break off and jam the
button.
CAUTION
UNINTENDED EQUIPMENT OPERATION/CONFIGURATION OVERWRIT-
TEN—RST BUTTON
Do not attempt to restart the island with the RST button. Pushing the RST button
reconfigures the island with default settings (no custom parameters).
Failure to follow these instructions can result in injury or equipment damage.