Installation manual

27InRow RC Installation Manual
5. Position the insulated chilled water
supply pipe

in the equipment.
Mount the gasket

and connect the
pipe to the union. Tighten the union to
20 Nm (14.8 ft-lb).
6. Insulate the joint with the provided
insulation (not shown).
7. Reinstall the air filter bracket

.
8. Reinstall the rear condensate drain
pan bracket

and the air filters.
9. Connect the water supply pipe

to
the field-installed water supply

using the gasket

saved from step
5, union end

, and union nut

.
na2576a