Installation manual

InRow RC Installation Manual24
Leveling the Equipment
NOTE: The leveling feet at the corners of the equipment provide a stable base if the floor is uneven, but they
cannot compensate for a badly sloped surface.
1. Remove the front and rear doors. See “Removing the front and rear doors” on page 21.
NOTE: Before removing the front door, unplug the ground wires and any other wire connections that
may interfere with the removal of the doors.
2. For each leveling foot, insert a Phillips PH2 or slotted
screwdriver into the screw above the leveling foot. Turn
the screw to the right to extend the leveling foot until it
makes firm contact with the floor.
3. Reinstall the front and rear doors.
NOTE: Use a 13-mm open-ended wrench to level the equipment without removing the doors.
CAUTION
SHOCK HAZARD
After reinstalling the front door, reconnect the ground wire and other wire connections.
Failure to follow these instructions can result in injury or equipment damage.
na1572a