Installation manual

23InRow RC Installation Manual
Removing the electrical panel cover
Remove the electrical panel cover to install the main power cable.
1. Remove the five M4 screws securing the cover.
2. Remove the cover by opening it and sliding it toward the front of the equipment.
Joining the Equipment to Enclosures
Joining to NetShelter
™
SX enclosures
The equipment comes with four joining brackets (two for the front and two for the rear).
1. Remove the front and rear doors.
See “Removing the front and rear
doors”.
2. Locate the four joining brackets.
Rotate each bracket ninety degrees
toward the adjoining enclosure so
the bracket is parallel to the floor and
install using the screws provided
with the enclosure.
For more information, see the Unpacking, Installation, and Customization manual for the NetShelter
SX Enclosure.
Joining to NetShelter VX and VS enclosures
For information on joining the equipment to NetShelter VX and VS enclosures, see the installation
sheet NetShelter
™
SX to VX or VS External Joining Kit—AR7601, AR7602.
WARNING
ELECTRICAL HAZARD
Ensure all wiring is not energized before routing cables into this equipment. Only qualified
service and maintenance personnel should work on this equipment.
Failure to follow these instructions can result in death, serious injury, or equipment
damage.
na2194a
ns0618a