Instruction manual

ConneXium Ethernet Switch 499NES18100 8-Port 10/100 Base-TX Quick Reference Guide
6 31005416 02 August 2004
The Eight-pin DIP
Switch
Using the eight-pin DIP switch on the front panel, you can suppress the messages
about the link status of any or all port connections:
LA1 If the switch is set to 0, the message to the DA/STAT 1 LED is suppressed.
LA2 If the switch is set to 0, the message to the DA/STAT 2 LED is suppressed.
LA3 If the switch is set to 0, the message to the DA/STAT 3 LED is suppressed.
LA4 If the switch is set to 0, the message to the DA/STAT 4 LED is suppressed.
LA5 If the switch is set to 0, the message to the DA/STAT 5 LED is suppressed.
LA6 If the switch is set to 0, the message to the DA/STAT 6 LED is suppressed.
LA7 If the switch is set to 0, the message to the DA/STAT 7 LED is suppressed.
LA8 If the switch is set to 0, the message to the DA/STAT 8 LED is suppressed.
Ground
Connection
The switch is grounded via the separated ground screw. It is located on the left
under the front panel.
Make sure that the electrical installation meets local or nationally applicable safety
regulations.
01
LA1
LA2
LA3
LA4
LA5
LA6
LA7
LA8