Instruction manual

ConneXium Ethernet Switch 499NES18100 8-Port 10/100 Base-TX Quick Reference Guide
10 31005416 02 August 2004
The equipment is delivered in a ready-to-operate condition. Follow this procedure to
assemble the switch.
Notes The front panel of the ConneXium 499NES18100 switch module is grounded via
a separate ground connection.
Do not open the module housing.
The shielding ground of the twisted-pair lines that can be connected is electrically
connected to the front panel.
Startup To start up the ConneXium 499NES18100 switch module, connect the supply
voltage via the five-pin terminal block.
Dismantling To take the ConneXium 499NES18100 switch module off the ISO/DIN rail, insert a
screwdriver horizontally under the housing into the locking slide, pull it downward
(without tipping the screwdriver), and lift the module upward.
Step Action
1 Check whether the DIP switch pre-settings suit your application (See The Eight-pin
DIP Switch, p. 6).
2 Pull the five-pin terminal block off the switch module and wire up the supply voltage
and indicator lines.
3 Fit the 499NES18100 on a 35 mm standard DIN EN 50 022 rail.
4 Attach the upper snap-on slide bar on the module to the DIN rail and press it down
until it locks in position.
5 Fit the signal lines.