Specifications

46
Presentation
Advantys STB
Distributed I/O Solution 1
Phaseo Regulated Power Supplies
The ABL-7 range of power supplies is designed to provide the d.c. voltage
necessary for the control circuits of automation system equipment. Split into three
families, this range meets all the needs encountered in industrial, commercial and
residential applications. Single-phase or 3-phase (1), of the electronic switch mode
type, they provide a quality of output which is suitable for the loads supplied and
compatible with the mains supply available in the equipment. Clear guidelines are
given on selecting protection devices which are often used with them, and thus a
comprehensive solution is provided which can be used in total safety.
These switch mode power supplies are totally electronic and regulated. The use of
electronics makes it possible to significantly improve the performance of these power
supplies which offer:
b compact size,
b integrated overload, short-circuit, overvoltage and undervoltage protection,
b a very wide range of permissible input voltages, without any adjustment,
b a high degree of output voltage stability,
b good performance,
b LED indicators on the front panel.
Phaseo power supplies are available in single-phase and 3-phase versions (1). They
deliver a voltage which is precise to 3%, whatever the load and whatever the type of
mains supply, within a range of 85 to 264 V for single-phase, or 360 to 550 V for
3-phase. Conforming to IEC standards, UL and CSA certified, they are suitable for
universal use. The inclusion of overload and short-circuit protection makes
downstream protection unnecessary if discrimination is not required.
ABL-7 RE and ABL-7 RP supplies are also equipped with an output undervoltage
control which causes the product to trip if the output voltage drops below 19 V, in
order to ensure that the voltage delivered is always usable by the actuators being
supplied. All the products are fitted with an output voltage adjustment potentiometer
in order to be able to compensate for any line voltage drops in installations with long
cable runs. Most of our power supplies are designed for direct mounting on 35 and
75 mm
7 rails.
The 24 AC single-phase power supplies referenced in this ctalogue are quite
adapted to tie-up with the Advantys STB modules (Network Interfaces Modules
“NIM”, Power Distribution Module “PDT” and inputs/outputs modules).
b Universal single-phase supplies ABL 7RE:
v power between 48 W (2 A) and 240 W (10 A),
v compact size,
v for all machine equipment,
v suitable for use in automation system environments based on the Micro and
Premium platforms or in any automation system configuration requiring a
c 24 V
supply.
b Universal single-phase supplies ABL 7RP:
v power between 60 W (2.5 A) and 240 W (10 A),
v output voltage available : c12, 24 and 48 V,
v
input filter (PFC) for commercial and residential environments (conforming to
standard EN 61000-3-2),
v two operating modes possible for handling of overload and short-circuit faults :
- "AUTO" mode which provides automatic restarting of the power supply on
elimination of the fault,
- "MANU" mode which requires manual resetting of the power supply to restart.
Resetting is achieved by switching off the mains power.
(1) 3-phase power supplies, consult our catalogue “Phaseo Power Supplies and Transformers”
ABL 7 power supplies
ABL 7RE240 p
ABL 7RP240 p
Phaseo switch mode power supplies
ABL 7RE2405
ABL 7RP2405
ABL 7RE2410
ABL 7RP2410
S
election:
p
age 48
Characteristics:
pages 49 and 50
Associations:
page 51
References:
page 51
Wiring:
page 51