Quick start manual

Premium and Advantys STB on Profibus DP.doc – Juni-05
Schneider Electric 26
Configuring
the hardware
1
Select Profibus network
interface module STB NDP
2212 as the island head.
2
Switch to the Parameters view
by double-clicking on the tab
in the header and adjust the
maximum station ID of the
CANopen extension as
necessary.
Note: This does not need to
be done in the example
project.
3
Next, add the remaining
stations STB PDT 3100, STB
DDI 3610,
STB DRC 3210,
and STB XPE 2100 and do not
forget bus connection
STB XMP 1100.
4
Finally, the CANopen
extension can be configured
by writing the devices to the
STB XPE 2100 module.
Addresses are assigned in
accordance with the order on
the bus.
Note: This may mean
switching the devices around
so that the addresses match
the order set in the hardware
configuration.