Quick start manual

Premium and Advantys STB on Profibus DP.doc – Juni-05

Schneider Electric

ATV31 variable speed drive

Introduction

The settings for the variable speed drives can either be made manually using the control

buttons on the device or by means of the PowerSuite configuration software. The

manual setting procedure is identical to the process described above for setting the

communication parameters and requires no further explanation here. However, at least

those parameters set for this software version should be set. The software-based setting

option is described below.

Connecting

the device

and reading

data

After starting the software, use

the “Connect” option in the

“Action” menu or the equivalent

button to establish a connection

with the device.

Note: Prior to this, you must

have inserted the connection

cable that runs between the PC

and ATV into the “PowerSuite”

port on the junction box. Only

one drive can be connected to

the box’s "ATV1" input.

Before the connection is

established, you must confirm

that you accept the terms of the

security warning by pressing

ALT+F.

Next, you need to enter the

name of the configuration or

device.

Continued on next page