Quick start manual

Premium and Advantys STB on Profibus DP.doc – Juni-05

Schneider Electric

Order of tasks

Proceed as follows to optimize the setup time of the individual products:

1. Parameterize the CANopen extension (station addresses, baud rate)

2. Parameterize the variable speed drive (adjust to suit the line frequency, motor,

etc.)

3. Configure Advantys STB and FTB (module assembly, parameterization, etc.)

4. Configure communication between PLC and Advantys STB (Sycon software)

5. Configure state machine for the DriveCom profile and user interface

Proceeding in the sequence described above will ensure that the relevant

information can either be imported directly or entered manually from the previous

action.