Quick start manual

Premium and Advantys STB on Profibus DP.doc – Juni-05
Schneider Electric 15
Communication
General
CANopen is used for communication within the drive island, i.e., between the fieldbus
devices (Advantys FTB and ATV31) and the I/O platform (Advantys STB). This is
referred to as the Advantys STB extension. The Profibus DP protocol is used for
communication between Advantys STB and the PLC. The cabling requirements are as
follows:
• CANopen cable between Advantys STB, ATV31 and Advantys FTB. The ATV31
drives are connected to the bus by means of junction boxes (VW3CANTAP2). A
special cable (VW3CANRR1) with RJ45 connector is used to connect the junction
box to the ATV.
• Profibus DP cable between PLC and Advantys STB. The PLC plug-in card connects
to the junction box (DP-TAB), from where the Profibus DP cable starts.
Premium PLC
TSX P57
5634M
Connection to PC:
The UNY XCA USB 033
remote connection cable is
used for the connection
between the PC’s USB ports
(Unity Pro) and the PLC.
Alternatively, a serial
connection (PC <->
TER/AUX) can be
established using a TSX
PCX 1031 cable (switch
position 0).
Connection with Advantys
STB:
A Profibus cable is used for
the connection. Be sure that
the interface to the PLC is
via Profibus Tab.
Advantys STB
Connection to PLC:
A Profibus cable is used for
the connection
(see the PLC chapter).
For the purpose of extending
the CAN bus, an appropriate
cable must be connected to
the XBE 2100 module.
Note: This module must be
the last local module in
Advantys STB.
Continued on next page