Installation guide

Safety
76
890USE17100 September 2003
STB XSP 3000
Assembly
Use the following procedure to assemble kit STB XSP 3000. After this is done go to
the next assembly procedure to attach cable clamps to the grounding bar.
Step Action
1 Open kit STB XSP 3000 and make sure you have the two side brackets, one
grounding bar and one FE grounding clamp. (Refer to the Kits section above).
2 Assemble an Advantys STB island segment.
3 Loosen the bracket lock down screw located on each side bracket. Attach the side
brackets to the DIN rail on both ends of your assembled Advantys STB island
segment. They will gently snap into place.
Side brackets
Lockdown screw