Installation guide

Installation
58
890USE17100 September 2003
Installing Advantys STB Modules in their Bases
Summary The insertion of an Advantys STB module into its base is very simple. The important
thing to remember is that you need to match the correct module with its appropriate
base. For this reason, an installation plan should be made before you begin the
actual installation process. The following procedures are to be implemented without
power connected to the island. For procedures implemented under power see Hot
Swapping Advantys STB Modules, p. 88.
Preliminary
Considerations
Before you install the modules in their bases, we recommend that you:
Make sure that you have the correct base in each position on the island
backplane
Use a keying strategy (See How to Key the I/O Module to Base Connection,
p. 46) to prevent modules from being installed in the wrong bases
Use the STB XMP 6700 marking label kit to clearly match modules to their bases