Installation guide

Installation
890USE17100 September 2003 57
How to Remove a
Termination
Plate
Use the following procedure to remove a termination plate at the end of primary or
extension segment.
Extending the
Island beyond a
Segment
If you intend to extend the island bus from one segment to another or to a preferred
device, do not use an STB XMP 1100 termination plate at the end of the first
segment. Select an STB XBA 2400 base as the last base on the segment, and install
it as you would any other base in the last position in the segment.
Depending on the type of extension you want to make, the STB XBA 2400 base may
house either an EOS module or a CANopen extension module.
Step Action
1 Remove the module directly to the left of the STM XMP 1100 termination plate.
2 With a firm grip on the lip at the center of the termination plate, pull the plate
straight out from its channel guides.
Note: If intend to extend to standard CANopen devices, a termination plate must
be added to the right of the STB XBA 2400 base.