Specifications

How to Configure the Island
EIO0000000051 6/2010 67
Configuring SNMP Agent Settings
Step Action
1 Double-click the NIM in the island editor to open the module editor.
2 Select the Ethernet Parameters page, then select the SNMP Agent tab to configure the SNMP agent
parameters.
3 In the Manager’s IP Address section, enter these IP addresses:
Manager 1 The first SNMP manager’s IP address contains 4 octet decimal values from
0...255. To use SNMP, you must configure an IP address for manager 1.
Manager 2 Manager 2 represents the IP address of the second SNMP manager.
NOTE: The first octet value of each SNMP manager IP address must be either in the range 1...126 or
128...223.
4 The following Agent fields are read-only. (The fields contain case-sensitive ASCII strings with a 32-
character maximum.):
System Name This user-defined string describes the STB NIP 2311 module.
System Location This string describes the location of the STB NIP 2311 module.
System Contact This string identifies the contact person for the STB NIP 2311 module.
5 In the Community Names section, enter the following passwords:
Get The Get, Set, and Trap passwords contain a maximum of 26 printable ASCII
characters. (You can leave these passwords empty.)
NOTE: The default setting for each community name is public.
Set
Trap
6 In the Enabled Traps section, select one or more of the following traps to enable reporting of that trap by
the SNMP agent. De-select a trap to disable reporting.
Cold Start Trap The agent is re-initializing and its configuration may be altered.
Link Down Trap One of the agent’s communication links has turned off.
Link Up Trap One of the agent’s communication links has turned on.
Authentication Failure
Trap
The agent received a request from an unauthorized manager.
7 Click one of the following:
z Apply: Save your edits and keep the module editor open.
z OK: Save your edits and close the module editor.