Specifications

STB NIP 2311 Services
EIO0000000051 6/2010 153
Configuring Ethernet Ports
Configure the STB NIP 2311 module’s two Ethernet ports after you have accessed
the module’s embedded web pages:
Step Action
1 Click on the Setup menu command to open the Setup page.
2 Select Ethernet Ports on the left to open the Ethernet Ports Configuration
page.
3 Select the Port Number to configure port 1 or port 2.
4 Select settings for the following parameters:
Speed The port speed:
z 10Mbps
z 100Mbps
z Auto-Negotiate: The module and the connected device
determine the appropriate port speed (the default setting).
Duplex Mode The duplex mode:
z Half-Duplex
z Full-Duplex
z Auto-Negotiate: The module and connected device
determine the appropriate duplex mode (the default setting).
Auto
Negotiation
Determines if the Auto-Negotiate value is available in the
Speed and Duplex Mode fields above. Select:
z Enable
z Disable
5 Click either:
z Apply: Save the Ethernet port configuration edits.
z Undo: Clear the page without saving your edits