Specifications

STB NIP 2311 Services
150
EIO0000000051 6/2010
The IP Configuration Page
Introduction
Perform these functions with the IP Configuration page:
z Select an Ethernet frame type.
z Enter stored IP address settings.
The stored IP addressing parameters set in this page are applied during power-up
under these conditions:
z The ONES rotary switch is set to STORED.
z The module is configured to obtain its IP parameters from a DHCP or a BootP
server, but no valid parameters are received.
The IP Configuration page:
Selecting a Frame Type
To specify an Ethernet frame type, select one of the following values in the
Ethernet Frame Format list:
z Ethernet II
z IEEE 802.3
z Auto: The device applies the appropriate format.
NOTE: A change made to the Ethernet Frame Format setting takes effect only
after you reboot the STB NIP 2311 module with the Reboot Page (see page 177).
Monitoring Control Diagnostics Maintenance Setup
IP CONFIGURATION Help
Apply Undo
Ethernet Parameters
IP Parameters
Ethernet Frame Format
IP Address
Subnet Mask
Default Gateway