Installation guide

16
Presentation
Advantys
™
STB Distributed I/O
Solution 0
Network Interface Modules
The STB Npp 2212 and STB Npp 1010 NIM (Network Interface Module), located at
the beginning of each island, are gateways for exchanging data between the network
or bus master PLC and the Advantys STB automation island.
The standard modules STB Npp 2212 also allow configuration and addressing of the
external devices of the installation. These settings are stored in the module’s internal
RAM or Flash memory. They can be saved on the STB XMP 4440 32 KB removable
memory card - apart from the address of the network connection point - in order to
copy the configuration of one island to another.
1 Fieldbus or network master.
2 External c 24 V power supply.
3 HMI terminal with Modbus
®
connection, Magelis
®
type XBT, XBT G, XBT GT
displays, see connection cables on page 92.
4 NIM (Network Interface Module).
5 PDM (Power Distribution Module).
6 I/O modules.
7 Second STB segment.
8 Other automation system.
9 Parallel interface module for Tego
®
application.
10 Parallel interface module for TeSys
®
Model U and TeSys
®
Quickfit
starter-controller.
11 Configurable safety controller Preventa
™
type XPS MC connected to the power
supply at the outputs of the power distribution module STB PDT p100.
12 Altivar
®
variable speed drive.
13 Festo
®
solenoid valves.
14 IP67 I/O Advantys FTB.
15 Parker
®
solenoid valves.
16 TeSys
®
Model U starter-controller.
Presentation
1
8
15910 9 12
6 134
3
2
145
7
6
11
5
16
This document provided by Barr-Thorp Electric Co., Inc. 800-473-9123 www.barr-thorp.com