User`s guide

FactoryCast Configurator
890 USE 152 00 Version 2.0 119
Resynchronizing Your Namespace with Its Database
Overview Over time, you may make changes to the Concept or PL7 database from which you
created your namespace. The Configuration Tool will only notify you of differences
between the database and your namespace when you try to make changes in the
namespace.
This section describes how the Configuration Tool notifies you and prompts you to
resynchronize your namespace with the database.
When
FactoryCast
Configurator
Asks You to
Resynchronize
FactoryCast Configurator will prompt you to resynchronize if you have changed the
Concept or PL7 database file and then try to:
l Add symbols or write-enabled direct addresses
l Delete symbols or write-enabled direct addresses
l Set the attributes of symbols
l Edit write-enabled direct addresses
Verifying
Discrepancies
Select Commands | ReSynchronize PLC Database to verify whether differences
exist between the current configuration and the corresponding database.
The ReSynchronization Status window appears to notify the user if differences are
detected between the configuration and the database.
Continued on next page