User`s guide

FactoryCast Configurator
110
890 USE 152 00 Version 2.0
Adding Direct Addresses
Overview If you only want users to view direct addresses, you do not need to include them in
the namespace. The The Data Editor and Graphic Editor can read any direct
address.
If you want users to be able to modify a direct address, you must include it in the
namespace. Any direct address included in the namespace is automatically write-
enabled.
This section describes how to import direct addresses into a namespace.
Premium
Register Values
The following register ranges are valid for Premium:
Continued on next page
CAUTION
CHANGES TO DIRECT ADDRESSES MAY RESULT IN CHANGES TO YOUR
APPLICATION
Be careful about which direct addresses you allow to be modified online, and be cautious
about who has permission to modify them. Unauthorized or incorrect changes to direct
addresses may change the behavior of your application in ways that may be undesirable or
even dangerous.
Failure to observe this precaution can result in injury or equipment damage.
Address Range Type R(ead)/W(rite) Access
%S0 - %S127 Boolean R/W
%SW0 - %SW255 Word 16 R/W
%SD0 - %SD254 Word 32 R/W
%M0 - %M12151 Boolean R/W
%MW0 - %MW31367 Word 16 R/W
%MD0 - %MD31366 Word 32 R/W