User guide

20
The 17D Series Servo Drive Family, continued
Equipment
Supplied
Each 17D servo drive includes the following hardware.
l Mating connectors X3, X4, X0
A
, X0
B
, X7 and X8
l Read me first.
Note: The mating Sub-D connectors and servo motor connector X9 are supplied
with the appropriate cable.
Equipment
Available
The following items are optionally available to you from Schneider for use with the
17D servo drives:
l Lexium BPH series brushless servo motors
l Servo motor power and feedback cables
Note: Power and feedback cables are available in lengths from 5...75 m and are
supplied by Schneider with the connector for the servo motor attached to the cable
and with the connector for the drive unassembled and unattached to the cable. The
10 m length cable is supplied (from stock) by Schneider with connectors attached to
each end of the cable.
l Optional Servo motor choke (for motor power cable lengths exceeding 25m)
l Optional External Regen resistor
l Serial communications cable (between drive and PC)
l Pre-configured cables for various Telemecanique and Modicon motion
controllers.
l Optional expansion cards.
Continued on next page