User guide

8
Hazards, Warnings and Guidelines, continued
CAUTION!
SAFETY INTERLOCKS
Schneider recommends the installation of a safety interlock with separate contacts
for each motor. Such a system should be hard wired with over–travel limit switches
and a suitable emergency stop switch. Any interruption of this circuit or fault
indication should:
l Open the motor contacts
l Shunt dynamic braking resistors across each motor, if they are present.
Failure to observe this precaution can result in equipment damage.
CAUTION!
ELECTROSTATIC COMPONENTS
The servo drives contain electrostatically sensitive components that may be
damaged by improper handling. Appropriately discharge yourself before touching
the servo drive and avoid contact with highly insulating materials (artificial fabrics,
plastic film, and so on). Place the servo drive on a conductive surface.
Failure to observe this precaution can result in equipment damage.
Continued on next page