Installation guide

RIO Network Hardware Components

890 USE 101 00 October 2006

F-to-BNC

Adapters for RG-

11 Cable

There is no approved BNC connector for RG-11 cable. Where a BNC connection is

required, use an approved F connector for the RG-11 cable followed by an adapter

connection such as the Modicon 52-0614-000 F-to-BNC Adapter.

The following illustration shows the F-to-BNC Adapter.

The 52-0614-000 Adapter permits the F connector on an RG-11 trunk cable to be

attached to the BNC connector on an RIO processor at the network head-end or the

F connector on an RG-11 drop cable to be connected to a J810/J812 or J890/J892

drop adapter at the drop.

BNC Jack to Male

F Connector

The 52-0724-000 Jack is supplied with the J890/J892-10x RIO drop adapters to

terminate cables with BNC connectors. Consult Sales; this product is available by

special order only.

Note: The S901, S908, or S929 head processors used in the 984A, 984B, and

984X Programmable Controllers require the use of a 52-0614-000 F-to-BNC

Adapter.

.437 in. Diameter

.403 in.

.566 in.

Diameter over Knurl

3/8 - 32 THD

Accepts Standard

Female F Connector

Female F Terminal

Accepts 18-22 AWG

Center Conductor

1.153 in.

.546 in.

Dia.

3/8 - 32 THD

.032 Diameter

7/16 Hex

This document provided by Barr-Thorp Electric Co., Inc. 800-473-9123 www.barr-thorp.com