Installation guide

Installing an RIO Network
112
890 USE 101 00 October 2006
10 Insert connector (with cable) into installation tool #490RIO0C411. Seat plastic
sleeve into the pocket of the tool jaw. Squeeze handles together. The black
plastic sleeve and the white pin insulator should both snap into place, with the o-
ring completely hidden under the collar. The white plastic insulator holding the
pin should be below or flush with connector interface.
11 Install the F connector onto the cable port of the RIO drop adapter, tap, or other
cable hardware device using a 9/16 in. open-end wrench.
Note: Finger tightening is not sufficient.
Step Action
This document provided by Barr-Thorp Electric Co., Inc. 800-473-9123 www.barr-thorp.com