Installation guide

Installing an RIO Network

890 USE 101 00 October 2006 111

8 To determine how far you should insert the cable, place the cable next to the

connector as shown. Position the dielectric at the installation groove (point A).

With your thumbnail, mark the cable jacket at the edge of the connector (point B).

9 Insert cable dielectric into the connector post. Push and twist connector until the

cable bottoms inside of the connector (point B should be even with the end of the

connector). Push the plastic sleeve into the connector until a snug fit is achieved.

Step Action

This document provided by Barr-Thorp Electric Co., Inc. 800-473-9123 www.barr-thorp.com