Installation guide

Installing an RIO Network
110
890 USE 101 00 October 2006
4 Release the tool handle and let the spring hold the tool on the cable. Slowly
rotate the tool 8 to 12 turns (as shown above) or until the tool turns freely. Let the
spring provide the cutting pressure. Pull the tool from the cable to complete the
cable prep.
5 Cable end should appear as shown.
6 If using single braid cables, fold the braid over the jacket. If using double braid
cables, fold the outer braid over the jacket. Score and remove foil (if applicable).
Fold the inner braid over the jacket.
7 Twist connector to remove from plastic sleeve. Plastic ring may stay attached
between connector collar and nut.
Step Action
5/16 in
9/16 in
TWIST
This document provided by Barr-Thorp Electric Co., Inc. 800-473-9123 www.barr-thorp.com