Installation guide

Installing an RIO Network
890 USE 101 00 October 2006 101
4 Open the jaws and remove the cable. Twist off the cable dielectric and jacket by
hand. Remove any long braid strands remaining around the prepared cable end.
(Long braid strands may indicate that a new blade pack is needed.) Remove any
dielectric on the exposed center conductor.
5 Fold all of the braid over the jacket. Avoid tearing the inner cable foil.
Once this cable preparation procedure is completed, you are ready to install RG-
6 connectors and/or adapters on the cable.
Step Action
3/16 in
23/64in
Braid Folded Over Jacket
This document provided by Barr-Thorp Electric Co., Inc. 800-473-9123 www.barr-thorp.com